I use the file name "Folder.jpg" as my artwork file. They will probably vary depending on the source of your audio files. Look under the album folders on your drive to see what name is used for the album artwork. You need to setup Soundirok (in "Settings" then "Devices") to find your artwork. In the settings something's mentioned about a script. I get all contents of the attached disc and can control it fine but no artwork. This is especially the case with firmware updates. I got myself in all sorts of bother when I became impatient with the unit in the early days and soon learnt to go off and make a cup of tea while the unit did it's thing. Here are screen shots of my setup to assist in getting it right.Īnother tip is to give Eunhasu plenty of time to respond as it can be quite slow. To ensure the USB drive can be accessed you need to ensure you have the correct settings in Eunhasu for the Library config and MPD config. Several friends have tried it and were quite surprised with the improvement it brought. The extra noise filtering on the vertical connection brings greater benefit to the USB drive than to the DAC. In fact I connect my USB drive to the dedicated DAC USB connection (vertical one) and use the other USB connection (horizontal one) to output to my DAC because it sounds better. Also it does not matter which USB connection you use on the unit as it will still work. I'm sorry but I have to disagree with Stefano's advice as I operate my unit with MPD and it does find the USB connected drive without having to install Minimserver or any other server. In my configuration, as in your, the USB content is not available as a share (even if Samba is checked), I can see the same icon you described Once you have selected it you should have all you music available in your control point Then you can find in your control point the music server which name is "MinimServer" To start you just need to define the path to your music files in the contentDir field in the configuration window of MinimWatch that is (must be) /mw/data/music Launch it and you should find an icon (red the first time) like a music note, click on it and the configuration window will show Once you have installed MinimWatch you'll be able to configure MinimServer on SMS-200. ![]() you'll find the links in the above installation guide Follow all the instructions, you'll need to install Java too if not already installed. Then you must configure it and you need to install on any computer you have on hand MinimWatch (here the link to MinimWatch installing instructions ). MPD cannot find the music itself, an upnp server is needed, then you have to install Minimserver on your SMS-200 I tried a couple of years ago and I had to. My issue is that when I try to save and close the Library configuration page it keeps thinking and it doesn't close.Ĭhecking on my mac Finder I see Eunhasu with the two USB1 and USB2 folders with a red round sign (like street sign no access).ītw, do you tick Samba like I explained above or not in your system? Yes I connected the hard disk to the USB1 plug (not audio USB).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |